How To Hang Grow Lights From Ceiling

Download Article

Download Commodity

Hanging a swag calorie-free or light fixture from your ceiling may seem like a daunting chore, just information technology'south actually rather simple. Yous only demand a few basic tools and a piffling fleck of time to tackle this project. If you ain the property, you lot can install a light fixture directly into the ceiling. If you lot rent, or just want a more temporary solution, y'all can hang a swag light from a hook or ballast and plug it into an outlet.

1. 1

   Plow off the circuit breaker that powers the calorie-free. Earlier you do anything else, you need to turn off the circuit breaker. If you aren't certain which breaker turns off the light, plow off the principal breaker and use natural light or a headlamp to complete this project.^[one]

2. 2

   Remove the old fixture, if applicative. Use a screwdriver to remove the screws, or an touch driver with a hex-shaft to remove the basics, that secure the canopy (the dome-shaped cover) to the ceiling. Then, employ a screwdriver to remove the screws that secure the batten to the electrical box. Disconnect the wires on the fixture from the wires in the ceiling by removing the wire connectors and untwisting the wires. Advisedly lower the old fixture to the floor.^[2]

   EXPERT TIP

   Jeff Huynh is the possessor of Moseybolt, a full service solution in domicile services, renovations, and repair in the Greater Seattle area. He has over five years of handyman experience. He has a BS in Business Administration from the San Francisco State University and his Certificate in Industrial Electronics Technology from North Seattle College.

   

   Brand sure your calorie-free will exist secure. According to Jeff Huynh, the general manager of Handyman Rescue Squad: "If you remove your light fixture and yous find a metal or plastic box, jerk the box to test the screws. If it'south not secure, y'all'll need to supersede it. If it seems sturdy and sound, yous can install a light fixture that weighs up to almost xv lbs (6.8 kg). Even so, if you're hanging a heavier fixture like a chandelier, yous'll need to install a axle into the rafters above the ceiling and hang the box and the light from that."

   Ad

3. three

   Get together the mounting strap for the new fixture. Follow the instructions that came with the new fixture. By and large, y'all'll need to line upwardly the crossbar with the back of the awning and thread the pipe or screws through the canopy. Only ¹⁄_four to ¹⁄₂ inch (0.64 to 1.27 cm) of the pipe should extend past the awning, so adjust the screws or pipage until that much is showing. Tighten the nuts to concord the screws or pipe in identify.^[3]

4. 4

   Attach the crossbar to the electric box. Enquire someone to concord the fixture while you do this. First, brand sure all the wires are on one side of the crossbar. And so, utilize a screwdriver to screw the crossbar to the electrical box on the ceiling. It should get across the center of the hole and be screwed in on either side.^[iv]

5. five

   Connect the similar wires to each other. You should connect the "hot" wire in the fixture to the "hot" wire in the ceiling, and the neutral wire in the fixture to the neutral wire in the ceiling. Generally, the hot wire is black or red and the neutral wire is white. Use wire connectors to connect the like wires to each other. Only twist the exposed parts of the wires together, then screw the connector onto the wires.^[5]

6. 6

   Wrap the ground wire clockwise effectually the ground spiral. At that place is a basis spiral on the crossbar that you installed, and it can usually be found just to 1 side of the center of the batten. Observe the basis wire, which is commonly dark-green or copper. Wrap the ground wire clockwise around the ground screw to tighten it.^[6]

7. vii

   Install the awning. Constrict all of the wires and wire connectors into the electrical box. Then, use a screwdriver or impact driver to secure the canopy to the ceiling. You can adjust the threaded rod or screws, if necessary, to make certain the canopy fits securely.^[7]

8. 8

   Add the low-cal bulbs and turn the power back on. If necessary, place light bulbs into the sockets of the fixture. Make sure they are rated for the type of fixture you lot purchased. Then, flip the circuit breaker to plow the power dorsum on.^[viii]

Advert

1. 1

   Purchase a swag light and cord kit. Look for a "swag" lite, which is one that is hung from the ceiling and plugged into a wall. This means yous don't take to do any electric work! The lamp and cord kit should contain the low-cal and shade, the cord with a plug, and anchors or hooks to install the light.^[ix]

   • Yous tin can find swag lamps and string kits at home comeback and dwelling decorating stores likewise as online.

2. 2

   Ensure the cord volition accomplish an outlet. Earlier you add hooks or anchors, think nigh where you lot want the lite to get. Determine if the cord is long enough to reach an outlet once you hang the light and run the cord forth the ceiling, then down a corner where 2 of your walls meet. If information technology's non, consider hanging the calorie-free somewhere else or adding an extension cord.^[10]

   • Running the cord downward a corner, rather than the center of a wall, makes for a more than attractive project.

3. iii

   Install 2 ceiling hooks or a ceiling hook and an anchor. If the low-cal y'all plan to hang is heavy, such as more than than 5 pounds (2.3 kg), employ an anchor rather than a hook to secure information technology to the ceiling. Situate this ballast or hook where you desire the light to hang from and screw it into the ceiling. The other claw should go in the corner of the room in which you plan to run the cord downwardly to the outlet.^[11]

4. 4

   Hang the lite from the claw or anchor. Remove all the packaging and screw the bulb into the socket, if necessary. Secure the lamp shade over the seedling and connect the cord, if applicable. And then, hang the string from the hook or anchor you installed so the lamp sits at the desired height.^[12]

5. v

   Plug the lite in, and then hide the cords with string covers if desired. Once you've gotten your light hung up, all that's left to do is plug it in! If y'all want a cleaner expect, consider covering the cord with cord covers. These are plastic tubes that conceal the cords and aid them stay in place. Merely slip the cord into the tube through the slit in the back. Then, skin off the adhesive backing and stick the encompass to the wall or ceiling.^[13]

Advertisement

Inquire a Question

200 characters left

Include your electronic mail address to get a message when this question is answered.

Submit

Advertisement

• Alternatively, you could hang cord lights on the ceiling to provide both light and ambience.

Advertisement

• If your home was wired before 1985, make sure the fixture you buy doesn't necessitate that your electrical wire is rated for xc °C (194 °F).^[14]

• If your new light fixture weighs more than than 50 pounds (23 kg), you may need to install a new electrical box to hold information technology.^[15]

• Aluminum wiring should not be contradistinct. If you take aluminum wiring, which is dark grey rather than copper, contact a certified electrician to aid you with this projection.^[16]

Advertisement

Things You'll Need

• Light fixture
• Screwdriver or impact driver
• Wire connectors

• Swag light
• Cord kit with hooks or anchors
• Screwdriver or impact driver (for anchors)
• Cord covers (optional)

Near This Article

Article Summary X

To install a lite fixture in the ceiling, begin by turning off the power. Remove the old fixture, so assemble the mounting strap for the new fixture as per the instructions. Attach the crossbar to the electrical box with a screwdriver. Connect the hot wire to the hot wire and the neutral wire to the neutral wire using wire connectors. Wrap the ground wire clockwise effectually the basis spiral on the batten. So, install the awning and turn the power back on. To learn how to hang a swag light from a ceiling hook, read on!

Did this summary help y'all?

Thank you to all authors for creating a folio that has been read 62,892 times.

Did this commodity help you?

Source: https://www.wikihow.com/Hang-Lights-from-a-Ceiling

Share this post